UNIVERSAL EQUAL POWER AUDIO PROCESSOR
WIRING DIAGRAM: UEPAP - UNIVERSAL EQUAL POWER AUDIO PROCESSOR
The UEPAP uses two PC boards hooked together to form a 4" wide PC board. The VCA-101 board should face the PANEL in the way normal to Serge Modules. Wiring, too, is normal for this board. The PAN-102 PC board departs from the typical Serge Module, and the following directions should be observed when wiring it to the PANEL:
Other wires which go to the pc board's pads should he imserted through the board and soldered on the top side.
Also: power supply wiring should be done in the normal way, and is only necessary connected to the VGA-101 board. Power supply connections have already been made to the PAN-102 PC board.
OTHER SPECIAL INSTRUCTIONS:
PRELIMINARY TEST USER'S INSTRUCTIONS:
Note: the stereo PAN outputs (2+4,1+3) are higher impedances (7.5k) than typical Serge outs. This is no problem when hooked to external amps, etc... They should however be buffered via MlXERS (or other audio modules) for use within the system (to avoid loss),